Articles in this section

Getting Started - PRO or AF Generator with Signature Series and Serenity Light and Music with SWM-1 (WiFi)

Avatar
Martin Siwy
Updated
Follow
Initial Setup
 

Step in the shower and locate the Signature Series controller on the wall.

Please verify:
  • that the controller has been mounted at the furthest possible point away from the steamhead.
  • the controller has been mounted inside the shower.
  • the Serenity Light and Music system is installed on the ceiling
 
Is the time displayed on the controller?

If NO - If you are not seeing the time and no LED lights up - you are not getting power to the controller.  Try the below steps:
  1. Make sure the Breaker for the generator is ON.
  2. Disconnect and reconnect the yellow Can-BUS cable on the generator side and the controller side.  
  3. Make sure to hand tighten the connections and gently push-in the cable connector to assure the pins are connecting.
  4. Please double check the cable and make sure that nails, staples or screws didn't "pinch" the cable during installation.
You can also try this troubleshooting Signature Series control not lighting up

If YES
 
Do you need to setup or adjust the time?

If YES - Changing Time On Signature Series Control
 
 
 
 
Now that we confirmed that all components are "talking" with each other we can start setting up your preferences.

Let's start with User 1 or User 2 for Shower Settings.  This is to setup your preferences when using Light and Music features without the steam when you are in the shower.
 

That's it, you're all set!
 
Next time you come back to take steam press USER 1 or 2 you preset then STEAM.  Your time and temperature will start.  To turn OFF the system before the timer runs out simply press the active USER.
 
Enjoy relaxation time at the privacy of your home :)

Related articles

Comments

0 comments

Please sign in to leave a comment.