ThermaTouch - Steam generator settings (ver. 10.0.10)

The steam generator settings page can be found under Equipment:

Then select Generator:

FastStart

This setting controls the tank standby heater:

There are three options:

1. Off
2. On
3. Green mode

Green mode will shut the heater off after 2 weeks of inactivity.

Maintenance data

These three fields display maintenance data that is stored in the steam generator:

• Run hours counts the lifetime hours of usage of the steam generator
• Maintenance interval counts the minutes of usage in the current cycle. After each 1000 minute cycle, the steam generator will enter a state of maintenance required. See the PowerFlush section for more information
• Time to next PowerFlush gives the minutes remaining until a cleaning cycle is required

PowerFlush

This option starts a PowerFlush cleaning cycle:

This cleaning cycle will be required by the steam generator periodically. The following link is a step by step guide for performing a PowerFlush:

ThermaTouch - PowerFlush (ver. 10.0.10)