ThermaTouch - Connect internet (ver. 8.4.5)

This tutorial will help connect the ThermaTouch to a Wifi or wired LAN network to provide an internet connection.

Wifi connection

Step 1:

Touch Settings icon then touch NETWORK:

 

---

Step 2:

Go to Wi-Fi Settings:

---

Step 3:

Android prioritizes the Ethernet (wired) connection, and will not connect to Wi-Fi if the Ethernet has been connected. TouchSteam can use either connection, but some third-party apps will only work with Wi-Fi connection. For this purpose, a switch has been provided to force the device to use Wi-Fi connection instead.

Look in the Notification bar at the upper right corner of screen to see if Ethernet is connected:

If you do NOT see this icon, then skip to Step 5

 

---

Step 4:

Touch the Back button:

Then touch Force Wi-Fi Connection:

Go to Wi-Fi Settings:

---

Step 5:

If not already on, turn on the Wi-Fi:

---

Step 6:

Select the network from the list:

---

Step 7:

Select Show password, type in your Password and touch Connect, then wait 15-30 seconds:

 

---

Step 8:

The network should show as Connected:

and the Wi-Fi icon should be shown in Notification bar at the upper right corner of screen:

Use the Back navigation button to return:

 

IP address

To view the IP address, touch Settings, then touch Network:

 

---

Go to Wi-Fi Settings:

---

Touch the three dots in upper right corner of screen:

 

---

Select Advanced:

---

Swipe up to view the IP address:

 

---

Touch the Back button several times to return:

 

Troubleshooting Wifi connection:

ThermaTouch was connected but lost internet connection

Touch Settings , then touch Network then Wi-Fi Settings. If your Wi-Fi network is saved, but not connected as shown below:

Touch the network SSID

Touch Connect

 

No networks are shown

Use another device to verify that the unit is within range of the Wi-Fi router. If the network shows up on another device, reboot the ThermaTouch:

ThermaTouch - Reboot device

If networks still are not shown, verify that the Wi-Fi antenna is connected to the back of the unit:

 

Wired LAN connection

The internet should connect automatically when a cable is connected to the jack on the back of the
ThermaTouch:

 This concludes the setup. Use the following steps to verify the LAN connection:

 

Step 1:

To verify that it’s connected, touch Settings then touch Network:

 

---

Step 2:

Go to Wi-Fi Settings:

Verify that the Ethernet icon is shown in Notification bar at the upper right corner of screen:

 

---

Step 3:

Touch the Back navigation button several times to return:

 

Troubleshooting Wired LAN connection:

ThermaTouch has no internet connection

If the ThermaTouch does not connect to the wired home Ethernet, try connecting it through an Ethernet switch that is located near the ThermaTouch. Use a cable less than 1m long for the connection from switch to ThermaTouch.